A new kitchen faucet is a simple and cost-effective way to modernize your kitchen. Purchasing and installing a sprayer will also cost you money.
So, can you install a kitchen faucet without a sprayer?
Here’s if you can install a kitchen Faucet Without The Sprayer
you can install a kitchen faucet without the sprayer. However, if your faucet has sprayer options, you should use them because they make the faucet more functional and easy to use.
How To Install A Kitchen Faucet Without A Sprayer?
To install a kitchen faucet without a sprayer, you must first replace the existing one. If you don’t want to utilize the sprayer, detach the extension line. Then take it out. To avoid using the sprayer, install a single-hand faucet.
Before you begin, turn off the main water supply to the house. For your safety, turn off the recirculating pump and the electric water heater.
Tools Required
First, you’ll need certain installation tools. These are the tools you’ll need to be ready for some handyman work. Here’s what you’ll require:
- A towel
- Supply lines
- A faucet plate
- Faucet gasket
- New faucet
- A screwdriver
- A bucket
- An adjustable wrench
- Basin Wrench
- Penetrating oil
Step #1 – Remove the old faucet
To install a new kitchen faucet, you must first remove the old one. It’s quite fine if you don’t know how to do it.
- First, wipe up the under-faucet area and remove any debris.
- Place a towel and a bucket inside.
- You must now switch off the main water supply. Check that all of the water has been drained from the faucet. You can gather the water with the bucket you set up.
- Turn off the hot and cold water shut-off valves at the same time. Turning the shut-off valves with strong movements can cause the valve handle to break.
- Begin by unplugging the faucet supply lines. Use a wrench or a pipe wrench to complete the task. Then, using the bucket, collect any excess water from the supply pipes.
- Remove the old supply lines from the faucet after disconnecting them.
- Unscrew the mounting nuts using your screwdriver. If they are difficult to unscrew, add penetrating oil to help.
- After removing the mounting nuts, remove the old faucet from the kitchen sink.
Step #2 – Installing the new faucet
Since you don’t want to utilize the sprayer, you can use a single-handed kitchen faucet.
- Insert your new faucet into the sinkhole. Remember that you must first remove the stripped set screws.
- Fill up the remaining sinkholes with a faucet plate. Faucet plates typically cover three sinkholes. A sinkhole cover can be used to conceal the fourth hole for a sprayer in your sink. It’s quite easy to set up.
- Now, insert the new supply lines (both hot and cold water lines) into the faucet. Tighten the mounting nuts under the sink. Ensure that someone is holding the faucet at that moment. Tighten the mounting bolts on the faucet with your pipe wrench.
- Attach the supply lines to the valves. Wrap some Teflon tape around the valve to ensure no leaks. Using your wrench, tighten the nuts.
- Turn on the main water valve as well as the faucet valves. Drain the water from the faucet for 2 minutes and check for any leaks. Always make an effort to conserve water. Save water by using the bucket.
- If you notice any leaks, replace the valves with more Teflon tape and rejoin them. If the leaking does not cease, contact a plumber.
- Remove the sprayer if you already have one but don’t wish to use it. Remove it from under the sink and plug the hole with a sinkhole plug.
How Do You Cap Off A Kitchen Sprayer?
Turn off the hot and cold water valves located beneath the sink. Then turn on the faucet and wait until the water runs out. Locate the end of the hose that is not connected to the sprayer. Using pliers, twist the valve at the hose’s base counterclockwise.
The kitchen sprayer connects to your faucet and is useful for cleaning dishes or winning an accidental water war. You can repair or replace your sprayer if it begins to leak from the hose, connector, or sprayer head.
Capping the connection point on the kitchen faucet is required if you choose to remove the sprayer. It also necessitates sealing the hole left in the sink or countertop when the sprayer is removed.
- Turn the water supply valves beneath the kitchen sink off. Turn on the faucet and pull the sprayer trigger to drain any remaining water in the supply lines, faucet, and sprayer.
- Trace the sprayer hose from the sprayer’s end to the faucet’s connection. Using pliers, unscrew the connector that connects the sprayer hose to the faucet.
- To expose the male threads, remove the sprayer hose from the faucet. Dry the threads with a towel. Pipe-joint tape should be used to wrap the threads.
- Twist a 3/8-inch brass threaded flair cap onto the male threads. Tighten the cap with the pliers.
- Loosen the mounting nut that secures the sprayer support to the sink or countertop beneath the sink. If you can’t reach the mounting nut with your hand, use a basin wrench.
- Remove the mounting nut from the hose that is connected to the sprayer beneath the sink.
- Remove the sprayer support and sprayer from the sink or countertop hole.
- Insert a sinkhole cover into the sprayer’s hole. Depending on the design of the hole cover, it may snap in or be held in place by a mounting nut.
What Can You Use To Cover The Sink Sprayer Hole?
Typically, deck plates can usually be used to conceal your sink sprayer hole. Some faucet bundles come with a matching deck plate, but you can also buy one separately for roughly $15-20.
Additionally, you may use the sink sprayer hole to install useful kitchen sink accessories. Because the apertures are already there, you can do this fast, efficiently, and affordably. (Keep in mind the accessory spacing restrictions as well as the location of the faucet handle.)
Here are some accessories you can add.
1. In-counter soap dispenser
The cheapest option here is an under-counter dispenser, which costs around $25. This dispenser can be used for hand soap, dish soap, lotion, or other liquids. Some folks even install two of them.
This stainless steel variant matches the majority of stainless steel faucets. Dispenser pumps are available in a variety of finishes, including brushed nickel and chrome.
2. Garbage disposal switch
Alternatively, you can move the waste disposal switch right next to the faucet. It’s more convenient, and it frees up your wall switch for other use. Many people are unaware of how simple this process is (you can do it yourself!).
An Air Switch Kit, a kitchen sink accessory, may be purchased for around $40. It is compatible with any disposal unit, and snap init comes in ten various finishes, allowing you to simply match it to your faucet, kitchen hardware, or tabletop.
Simply connect the air switch to the wall outlet located beneath your sink. After that, connect the garbage disposal to the air switch. There is no special wiring required!
3. Water Filter or Instant Hot Water Dispenser
You may be able to install either an instant hot water dispenser or an under-counter water filter unit depending on the location of the sink sprayer hole and the available space. These sink additions typically cost between $100 and $250.
Without the assistance of a plumber, you can install the water filter (about $100) in less than 30 minutes. Then you can enjoy fresh filtered water without having to install an unattractive above-counter filter or buy bottled water.
The installation of the instant hot water dispenser is equally simple. There are no tools necessary.
4. Glass rinser
That sink sprayer hole in your sink can now be transformed into an easy-to-use glass rinser, making cleaning your glasses a breeze!
Simply connect the glass rinser (available in 7 various finishes to match your faucet) to a hot or cold water line and rinse any glass between 1″ and 3.6″ in diameter.
You’ll appreciate being able to effortlessly wash water bottles, coffee cups, travel mugs, and baby bottles from an empty hole that was just waiting for better use.
Bottom Line
The faucet will work even if the sprayer is not connected. It connects to a quick-connect valve, which remains closed if the additional hose is not connected. You’d just be overpaying for the side spray you’re not utilizing.
Sources
https://www.quora.com/Can-you-install-a-kitchen-faucet-without-the-sprayer
https://www.houzz.com/discussions/2701264/kitchen-faucet-living-without-spray
